Tangential control jogging?
Posted: Fri Apr 12, 2024 1:57 pmHi, have question is it possible to setup uc to jog X and Y axis in direction of the current set tangent A axis without a actual code loaded?
I know it works with code loaded or MDI.
If I want to manually jog A axis to some angle and then with one button have X and Y calculate the trajectory for correct motion.
Will it be a custom macro button?
Thank you.
I know it works with code loaded or MDI.
If I want to manually jog A axis to some angle and then with one button have X and Y calculate the trajectory for correct motion.
Will it be a custom macro button?
Thank you.