Interupted Cycle Feature

Post anything you want to discuss with others about the software.

Interupted Cycle Feature

Postby Vmax549 » Sat Feb 04, 2017 3:42 am

This feature is called interupted Cycle. When you have a complicated table with lots of fixturing you may have to Weave your way out of a stopped position to do it safely. This feature when activated allows you to LOG each move you have to do to get clear of fixturing . You can log up to 5 moves. When you are ready to restart it retraces your moves to return you back to where you were for a restart. It also sets your SafeZ to teh Z level you started at and returns teh SafeZ to its original value at finish.

With this feature you can do a feedhold at teh bottom of a hole that you are Undercutting. OR when thread milling where you are undercutting teh threads. It allows you to back away to clear teh material then return back to teh same exact height before teh RFH restarts you cycle.

(;-) TP
Attachments
InteruptCycle.jpg
Vmax549
 
Posts: 1294
Joined: Sun Nov 22, 2015 3:25 am
Location: USA

Return to General discussion about the UCCNC software

Who is online

Users browsing this forum: No registered users and 4 guests