Page 1 of 1

uccnc running old analogue servos - done!

PostPosted: Mon Jan 30, 2017 1:09 pm
by Battwell

Re: uccnc running old analogue servos - done!

PostPosted: Mon Jan 30, 2017 8:23 pm
by andrewbishop66
Hi nice work notice you are using a chinese bob is it ok for a cheap board

Thanks Andrew

Re: uccnc running old analogue servos - done!

PostPosted: Mon Jan 30, 2017 8:57 pm
by Battwell
yes- they work really well. i have 6 in use on different machines for about a year- no problems
i like them as they are fully isolated if run off a seperate power supply

Re: uccnc running old analogue servos - done!

PostPosted: Mon Jan 30, 2017 9:25 pm
by Battwell
ive left this running all day- at simulated speed- on my machine of 60m/ minute (as fast as it will go)
no steps or position loss after 8 hours repeated program runtime. im running at present with 4000ppr encoder setup.

next step will be to change one axis ( x) on my big hobby machine to torque mode and try it against the existing step/direction setup before refitting one of the other big old machines i have at my workshop :-)
it tuned up way better than i got with mach3 and the galil plugin :-) dead smooth- no jumping around