Re: Issues With UCCNC software
Posted:
Sun Jan 08, 2017 11:28 pm
by charliem
Hi Gerry Thanks I will try what you suggested and post back. Thanks.
CNCDRIVE,
Thanks for the reply. I will look at the info and hopefully I can learn something.
Re: Issues With UCCNC software
Posted:
Mon Jan 09, 2017 11:37 am
by charliem
Hello Everyone,
So I learned a few things. First my jerky movements were associated with the feed rate. I slowed down the feed rate and it smoothed things out a bit. I loaded another Gcode file and all the jerkyness went away. I then set the feed rate back to 100% everything works as expected. It seems that the first gcode file I was messing with has a lot of short segments. I can post the offending file if anyone wants to confirm this.
Also I played with the Min Pwm settings and I have my spindle speed close enough.
Thanks to everyone who helped me on this.