Fusion Post processor

Post anything you want to discuss with others about the software.

Fusion Post processor

Postby Delco » Wed Nov 20, 2019 12:02 am

Hi , I have been using the uccnc post processor from autodesk but I have decided to try the wear function out in fusion and uccnc , problem is the uccnc post processor doesnt allow it.

I have been told to use a mach3 post processor - are there any differences I need to be aware of or is it fully compatable with uccnc ?
Delco
 
Posts: 354
Joined: Tue Apr 02, 2019 4:23 am

Return to General discussion about the UCCNC software

Who is online

Users browsing this forum: No registered users and 9 guests