Page 1 of 1

G20-G21

PostPosted: Tue Apr 16, 2019 4:51 pm
by RWC
Hi.
Forum search G20, G21 reveals 0.
I see that G20 ,G21 are not in the supported codes list and am wondering if many folks need, or would like the utility of G20-21 the way it is in Mach3/4.
Is it in any plans for implementation in the UCCNC SW ?

Just curious :?:

Thanks,
:)

Re: G20-G21

PostPosted: Tue Apr 16, 2019 4:57 pm
by ger21
Make two separate profile, one in inches, one in mm's, if you need to run both.

That's the preferred way to do it in Mach3.

Re: G20-G21

PostPosted: Tue Apr 16, 2019 6:11 pm
by RWC
OK !
That'll work. ;)
Shut down one, then start up the other .... then back again. No biggie as it is seldom.
I do like the way Mach4 handles it though :mrgreen:
Thanks Gerry,
Russ
:)

Re: G20-G21

PostPosted: Tue Apr 16, 2019 6:43 pm
by Vmax549
It should be possible to change that on teh fly with a macro. M20 /M21

Just a thought, (;-) TP

Re: G20-G21

PostPosted: Tue Apr 16, 2019 6:49 pm
by RWC
Hi Terry,
That would be cool !
Do you know if one exists ?
It's WAY above me to write one. :?

Thanks,
Russ