upside down cutting

Post anything you want to discuss with others about the software.

upside down cutting

Postby jdancer » Tue Dec 25, 2018 1:50 am

Happy Holidays
Upside down cutting
Need some help sorting out my problem? I am using USCNC software with a UC400ETH controller fully licensed and installed. The CNC seems to operate in all its operations except for one confusing factor. After loading the code, zeroing the mill and pressing cycle start. The tool begins to cut the top of the object shown on the screen upside down. Any ideas what I did wrong?
Thank you J. dancer
jdancer
 
Posts: 1
Joined: Tue Dec 25, 2018 1:36 am

Re: upside down cutting

Postby dezsoe » Tue Dec 25, 2018 6:55 am

If your g-code is shown good in the toolpath viewer then you have to invert the Y direction. Check/uncheck Active low on the Y axis setup page.
dezsoe
 
Posts: 2049
Joined: Sun Mar 12, 2017 4:41 pm
Location: Csörög, Hungary


Return to General discussion about the UCCNC software

Who is online

Users browsing this forum: Bing [Bot] and 7 guests