Rotary axis ( A axis)

Post anything you want to discuss with others about the software.

Rotary axis ( A axis)

Postby naijin » Sun Sep 23, 2018 11:14 am

Hi there, just starting to build a rotary axis for my cnc router, just wondering how to calibrate the A axis when it is complete?
any ideas or suggestions would be greatly appreciated

Nick
naijin
 
Posts: 31
Joined: Mon Dec 04, 2017 11:24 pm

Re: Rotary axis ( A axis)

Postby ger21 » Sun Sep 23, 2018 11:27 am

multiply the steps/rev of the motor times the reduction ratio. That should get you pretty close.
Then command the rotary to make 10 revolutions (or more), and see if it ends up where it started. If not, start making small adjustments, and test again.
Gerry
UCCNC 2017 Screenset - http://www.thecncwoodworker.com/2017.html
ger21
 
Posts: 1219
Joined: Sat Sep 03, 2016 2:17 am


Return to General discussion about the UCCNC software

Who is online

Users browsing this forum: Bing [Bot] and 4 guests