settings for speed control in CNCNC

Post anything you want to discuss with others about the software.

settings for speed control in CNCNC

Postby Jimamato » Thu Sep 20, 2018 3:52 pm

I have used my smooth stepper, PMDX-126 board and PMDX-107 board for speed control for about three years now. It has worked well with Mach 3 but I have decided to give up on Mach3 and try UCCNC on my router.
My new configuration is as follows. A UC400ETH controller and both my PMDX 126 and 107 cards. I have configured my newly installed UCCNC software and all my functions seem to work except one. I am able to turn the router on successfully but in no way can I control the speed.
Any help I may get would be gratefully appreciated.
Thank you very much.
Jim
Jimamato
 
Posts: 15
Joined: Mon Sep 17, 2018 8:39 pm

Re: settings for speed control in CNCNC

Postby cncdrive » Thu Sep 20, 2018 9:11 pm

You can control the spindle the exact same way in the UCCNC as the Mach3.
I know this is not much help, but we need specific question to help you.
cncdrive
Site Admin
 
Posts: 4695
Joined: Tue Aug 12, 2014 11:17 pm


Return to General discussion about the UCCNC software

Who is online

Users browsing this forum: No registered users and 18 guests