Page 1 of 1

Router Config settings

PostPosted: Tue May 15, 2018 12:51 am
by Jim Dandy
Hey all, I’m new here and just getting started with cnc. I built a Solsylva machine and am using uccnc software. I am trying to figure out the best Config settings for wood router work. My x axis is a lead screw 3/8-8-4 with 2 start. 4 turns per inch.
Does anyone have an idea of what the velocity and acceleration numbers should be? I calculated the steps per unit at 2546.7 thanks. And if anyone has a router profile they would like to share it would be much appreciated...thanks again...jim

Re: Router Config settings

PostPosted: Tue May 15, 2018 12:59 am
by ger21
Velocity and Acceleration settings are very much machine specific, and are best figured out through trial and error testing.