Tool Type Field in Tool Table

Post anything you want to discuss with others about the software.

Tool Type Field in Tool Table

Postby Vmax549 » Wed Mar 07, 2018 4:35 pm

Here is an example of using the ToolType field in teh new tool table .

Each tool is assigned a tool type that represents an Image of that type tool. In this example Tool #15 is a 3" FaceMill.

At a manual tool change IF the tool image is of a FaceMill and you have a 10mm tap in your hand ready to install there MAY be a problem. :o

(;-) TP
Attachments
UCCNC_ToolType.jpg
Vmax549
 
Posts: 922
Joined: Sun Nov 22, 2015 3:25 am
Location: USA

Return to General discussion about the UCCNC software

Who is online

Users browsing this forum: Bing [Bot] and 2 guests