CNC parking after executing a file

[drdus]

Hi Guys! I solved the same problem using the M9 macro. V-Carve generates M30 and M9 at the end of the G-code. The M30 macro does not start, but the M9 does, which is sufficient for my needs - after the job is finished, the spindle parks in the position specified in M9.TXT.
Regards!
Drdus

[drdus]

Hi Guys! I solved the same problem using the M9 macro. V-Carve generates M30 and M9 at the end of the G-code. The M30 macro does not start, but the M9 does, which is sufficient for my needs - after the job is finished, the spindle parks in the position specified in M9.TXT.
Regards!
Drdus