G41 / G42 feed compensation

Post anything you want to discuss with others about the software.

Re: G41 / G42 feed compensation

Postby skillalot » Sun Dec 02, 2018 10:37 pm

Appendix A, chapter 5, see the discription of G94. It's in the manual.
On phone now, can add screenshot tomorrow
skillalot
 
Posts: 7
Joined: Sat Nov 03, 2018 7:53 pm

Re: G41 / G42 feed compensation

Postby ger21 » Sun Dec 02, 2018 11:02 pm

Under G94, the feed rate will apply to the actual path of the cutter tip, not to the programmed contour.

I'd want to verify with them that the feedrate will vary from straight to radius moves, as this one sentence description is rather vague.
Gerry
UCCNC 2017 Screenset - http://www.thecncwoodworker.com/2017.html
ger21
 
Posts: 1187
Joined: Sat Sep 03, 2016 2:17 am

Previous

Return to General discussion about the UCCNC software

Who is online

Users browsing this forum: No registered users and 1 guest