Upto 400kHz step frequency operation UC300ETH

This Section is for users to discuss hardware

Upto 400kHz step frequency operation UC300ETH

Postby alex_s » Mon Sep 25, 2017 6:58 pm

Was wondering if the 400kHz is per axis or a total for all.

cheers
Alex
alex_s
 
Posts: 65
Joined: Tue Nov 29, 2016 11:45 am

Re: Upto 400kHz step frequency operation UC300ETH

Postby ger21 » Mon Sep 25, 2017 6:59 pm

Each axis can output at 400Khz.
Gerry
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
ger21
 
Posts: 2663
Joined: Sat Sep 03, 2016 2:17 am

Re: Upto 400kHz step frequency operation UC300ETH

Postby cncdrive » Mon Sep 25, 2017 8:44 pm

400kHz per axis, I mean every axis can do 400kHz step frequency.
cncdrive
Site Admin
 
Posts: 4695
Joined: Tue Aug 12, 2014 11:17 pm

Re: Upto 400kHz step frequency operation UC300ETH

Postby A_Camera » Tue Sep 26, 2017 8:29 am

alex_s wrote:Was wondering if the 400kHz is per axis or a total for all.

cheers
Alex

Watch out for setting to 400kHz. If your drivers can't handle that (and most of them can't) then it will cause some missing steps and/or stalling.
A_Camera
 
Posts: 638
Joined: Tue Sep 20, 2016 11:37 am

Re: Upto 400kHz step frequency operation UC300ETH

Postby alex_s » Wed Sep 27, 2017 11:58 am

A_Camera wrote:
alex_s wrote:Was wondering if the 400kHz is per axis or a total for all.

cheers
Alex

Watch out for setting to 400kHz. If your drivers can't handle that (and most of them can't) then it will cause some missing steps and/or stalling.


the Servos and drives ask for a minimum of 125kHz, but if it is 400kHz per axis then all is fine :)

Thx ger21 and cncdrive for the confirmation.

cheers
Alex
alex_s
 
Posts: 65
Joined: Tue Nov 29, 2016 11:45 am


Return to Hardware

Who is online

Users browsing this forum: No registered users and 2 guests