Drive train Pulses

[Graham90]

I looked for a heading that said dumb questions but could not find one, so...

OK my Proxxon ff500 has a direct coupled stepper motors on x and y that have 1600 pulses per rev and a pitch of screw of 4mm so for 1mm of travel I need 400 pulses?

On the z axis the stepper motor is coupled via a toothed belt and the ratio is 1:2, 2 being on the screw which also has a 4mm pitch, so does that mean I now have 800 pulses per 1mm on this axis?

[sebba]

yes, correct