Page 3 of 3

Re: Laser/spindle combo

PostPosted: Sun Jun 03, 2018 4:47 pm
by cncdrive
The polarity for the laser on is then probably the opposite for the laser as for the spindle on. (active low setting)

Re: Laser/spindle combo

PostPosted: Mon Jun 04, 2018 6:56 pm
by sngatlanta
cncdrive wrote:The polarity for the laser on is then probably the opposite for the laser as for the spindle on. (active low setting)


I switched the active Low setting for the I/O and the Spindle Active Low on and off, to all compinations and still the Laser is on when the Spindle ( M3 ) command is off. When given the m3 command to turn on the Spindle I regain control of the lasers m10 and m11 comands.

Any help is appreciated.

Re: Laser/spindle combo

PostPosted: Mon Jun 04, 2018 7:10 pm
by dezsoe
Could you upload your profile? There must be something misconfigured.

BTW, did the G52 work for you?