Laser/spindle combo

This Section is for users to discuss hardware

Re: Laser/spindle combo

Postby cncdrive » Sun Jun 03, 2018 4:47 pm

The polarity for the laser on is then probably the opposite for the laser as for the spindle on. (active low setting)
cncdrive
Site Admin
 
Posts: 2003
Joined: Tue Aug 12, 2014 11:17 pm

Re: Laser/spindle combo

Postby sngatlanta » Mon Jun 04, 2018 6:56 pm

cncdrive wrote:The polarity for the laser on is then probably the opposite for the laser as for the spindle on. (active low setting)


I switched the active Low setting for the I/O and the Spindle Active Low on and off, to all compinations and still the Laser is on when the Spindle ( M3 ) command is off. When given the m3 command to turn on the Spindle I regain control of the lasers m10 and m11 comands.

Any help is appreciated.
sngatlanta
 
Posts: 23
Joined: Wed Jan 10, 2018 11:12 pm
Location: Little Rock, AR USA

Re: Laser/spindle combo

Postby dezsoe » Mon Jun 04, 2018 7:10 pm

Could you upload your profile? There must be something misconfigured.

BTW, did the G52 work for you?
dezsoe
 
Posts: 478
Joined: Sun Mar 12, 2017 4:41 pm
Location: Csörög, Hungary

Previous

Return to Hardware

Who is online

Users browsing this forum: No registered users and 1 guest