HI All,
Does anyone have any experience with connecting the NVBDH+ (+ indicates Hall units in spindle motor) spindle driver to the UC400ETH???
I have the steppers (axis) working fine, but can't get the spindle motor to turn on. Have had the wiring independently checked, the fuse inside the NVBDH+ is good, red led on (power to unit working), and there is 48 volts into the unit. Currently I have NO connections from the NVBDH+ to the UC400ETH, just using the panel on the NVBDH+.
Any steps that I can try to get this working.
Your help is greatly appreciated.
Regards Jeff