DG4S-08020 large scale 3D printer
Posted: Wed Feb 28, 2018 8:33 pmI have been working on a large scale 3D printer, I would like to experiment with servo drives instead of the hobby standard stepper motors.
I purchased 2 DG4S-08020 a year ago, and I am finally at a stage to try them out.
I wanted to make sure I am reading the documentation correctly that the step/dir logic (pin 1, 2) needs to be 12 volt on the main rj45 jack?
I am planning on using a 5v to 12v shift logic controller if that is the case.
I purchased 2 DG4S-08020 a year ago, and I am finally at a stage to try them out.
I wanted to make sure I am reading the documentation correctly that the step/dir logic (pin 1, 2) needs to be 12 volt on the main rj45 jack?
I am planning on using a 5v to 12v shift logic controller if that is the case.