DG4S-08020 large scale 3D printer

This Section is for users to discuss hardware

DG4S-08020 large scale 3D printer

Postby chad419@gmail.com » Wed Feb 28, 2018 8:33 pm

I have been working on a large scale 3D printer, I would like to experiment with servo drives instead of the hobby standard stepper motors.

I purchased 2 DG4S-08020 a year ago, and I am finally at a stage to try them out.

I wanted to make sure I am reading the documentation correctly that the step/dir logic (pin 1, 2) needs to be 12 volt on the main rj45 jack?
I am planning on using a 5v to 12v shift logic controller if that is the case.
chad419@gmail.com
 
Posts: 1
Joined: Wed Feb 28, 2018 8:21 pm

Re: DG4S-08020 large scale 3D printer

Postby cncdrive » Wed Feb 28, 2018 11:30 pm

No, the step/dir signals can be 5V TTL level.
cncdrive
Site Admin
 
Posts: 2366
Joined: Tue Aug 12, 2014 11:17 pm


Return to Hardware

Who is online

Users browsing this forum: No registered users and 4 guests

cron