UC300 USB transient/noise problem
Posted: Sun Feb 25, 2018 3:10 pm
Hi
My UC300 USB motion controller fail and loses connection almost every time the spindle, water pump or coolant pump turns on or off.
I guess there’s a problem with transients, but what is recommended to do. I probably could isolate the pumps but the vfd is connected to the breakout card so the problem would remain. Please help!
My UC300 USB motion controller fail and loses connection almost every time the spindle, water pump or coolant pump turns on or off.
I guess there’s a problem with transients, but what is recommended to do. I probably could isolate the pumps but the vfd is connected to the breakout card so the problem would remain. Please help!