UC300 USB transient/noise problem

This Section is for users to discuss hardware

UC300 USB transient/noise problem

Postby RonnieJ » Sun Feb 25, 2018 3:10 pm

Hi
My UC300 USB motion controller fail and loses connection almost every time the spindle, water pump or coolant pump turns on or off.

I guess there’s a problem with transients, but what is recommended to do. I probably could isolate the pumps but the vfd is connected to the breakout card so the problem would remain. Please help!
RonnieJ
 
Posts: 1
Joined: Sun Feb 25, 2018 3:04 pm

Return to Hardware

Who is online

Users browsing this forum: No registered users and 16 guests