Update firmware on every UCCNC start, then lost connection

This Section is for users to discuss hardware

Update firmware on every UCCNC start, then lost connection

Postby shad » Wed Feb 14, 2018 3:22 pm

Hello Balazs!
Please tell me what can happens with controller?
On every UCCNC start the program initiate firmware update.
Update done, but then UCCNC lost connection to the controller.
We try to use 1.2047 version and 1.2102 version no sense.
This is a short video about issue https://yadi.sk/i/YDPUWA9p3SPri7

Thank you!
-- Andrew
UC400ETH
UC300ETH-5LPT
NEURON Lite THC
http://neuroncnc.com/
shad
 
Posts: 263
Joined: Thu Sep 15, 2016 5:23 pm

Re: Update firmware on every UCCNC start, then lost connecti

Postby cncdrive » Wed Feb 14, 2018 4:51 pm

Is it with direct connection to the PC or via router?
If it is via router then can you try it with direct connection?
Also try to disable the DHCP in the controller.
And you could also try to reset the controller.
cncdrive
Site Admin
 
Posts: 1860
Joined: Tue Aug 12, 2014 11:17 pm

Re: Update firmware on every UCCNC start, then lost connecti

Postby shad » Thu Feb 15, 2018 5:30 am

Thank you!
I will try and report.
-- Andrew
UC400ETH
UC300ETH-5LPT
NEURON Lite THC
http://neuroncnc.com/
shad
 
Posts: 263
Joined: Thu Sep 15, 2016 5:23 pm


Return to Hardware

Who is online

Users browsing this forum: No registered users and 1 guest