wire alarm to axbb-e

This Section is for users to discuss hardware

wire alarm to axbb-e

Postby Alexi » Tue Sep 08, 2020 10:46 pm

Hello to all members,
Sorry for my bad English.

I´d like to know how can i connect the alarm signal of my leadshine AM882 to my controller AXbb-E ?
All other connections are similar to axbb-E manual.

If i wire for example Alarm+ to pin 12 and alarm- to ground will it work or will it typical make smoke signal?
I try to check for continuity on circuit and force error but circuit remains open for both conditions in normal run and in error with red led blinking.
Is this just o "normal" NC or NO contact? Manual of drivers is not that clear.


Thanks in advance for help
Alex
Alexi
 
Posts: 8
Joined: Tue Sep 08, 2020 10:30 pm

Re: wire alarm to axbb-e

Postby dezsoe » Wed Sep 09, 2020 8:51 am

Hello Alex,

Connect 24V+ to I2+, I2- to Alarm+ and Alarm- to 24V0.
dezsoe
 
Posts: 1184
Joined: Sun Mar 12, 2017 4:41 pm
Location: Csörög, Hungary

Re: wire alarm to axbb-e

Postby Alexi » Wed Sep 09, 2020 1:05 pm

Hello,

Thanks for help.

This means that it will act as a regular switch no/nc type?
Should I have any continuity when drive gives an error?


Thanks
Alexi
 
Posts: 8
Joined: Tue Sep 08, 2020 10:30 pm

Re: wire alarm to axbb-e

Postby dezsoe » Wed Sep 09, 2020 3:49 pm

Yes and yes. But it will conduct only in one direction, because it's like a diode. (Search for open collector NPN.)
dezsoe
 
Posts: 1184
Joined: Sun Mar 12, 2017 4:41 pm
Location: Csörög, Hungary

Re: wire alarm to axbb-e

Postby Alexi » Wed Sep 09, 2020 5:16 pm

Thanks mate. I will search more for collector NPN.
Alexi
 
Posts: 8
Joined: Tue Sep 08, 2020 10:30 pm

Re: wire alarm to axbb-e

Postby Alexi » Wed Sep 16, 2020 3:53 pm

Hi

Can you tell me what config should i put on mach3 for this wiring?
I can only choose from pin10-13 and 15.

Thanks
Alex
Alexi
 
Posts: 8
Joined: Tue Sep 08, 2020 10:30 pm

Re: wire alarm to axbb-e

Postby Alexi » Wed Sep 16, 2020 4:13 pm

Solved port2.

Thanks
Alexi
 
Posts: 8
Joined: Tue Sep 08, 2020 10:30 pm


Return to Hardware

Who is online

Users browsing this forum: No registered users and 3 guests