Wait for ArcOn

This is the place to talk about and share things related to CNC plasma machines using UCCNC

Wait for ArcOn

Postby attila0216 » Thu Nov 23, 2017 8:06 pm

Maybe someone could explain to me what cause the issue that even if i have THC ON in G code, when pierce delay is 0,1 sec UCCNC giving out motion before plasma Arc is On. Shouldn't UCCNC wait for ARCON and only after this signal release motion? I have Arc on when Hypertherm is on with i bit of delay, but i guess UCCNC should wait no? Today I couldn't cut circles on my part because motion started before Plasma was on, and resulted a three-qourter circle not a full.

Any Idea?
attila0216
 
Posts: 15
Joined: Wed Feb 08, 2017 11:37 pm

Re: Wait for ArcOn

Postby cncdrive » Fri Nov 24, 2017 4:36 am

Yes, UCCNC waits with the motion for the Arc on signal to be active, if the THC and M3 is active.
If the THC or M3 is inactive then it will not wait.
cncdrive
Site Admin
 
Posts: 4695
Joined: Tue Aug 12, 2014 11:17 pm


Return to CNC Plasma

Who is online

Users browsing this forum: No registered users and 2 guests