M5 delay UCCNC+NeuronLite

This is the place to talk about and share things related to CNC plasma machines using UCCNC

M5 delay UCCNC+NeuronLite

Postby tõnisson » Wed Feb 07, 2018 8:06 am

When XY movement stops, there is a 1+ sec delay before torch shuts off.
What could cause a delay that long?



Kristian
tõnisson
 
Posts: 2
Joined: Thu Feb 23, 2017 8:19 am

Re: M5 delay UCCNC+NeuronLite

Postby cncdrive » Wed Feb 07, 2018 1:42 pm

What is controlling the torch? The UCCNC via a motion controller pin controlled by a M3/M5 or via the Neuron or a combination of both?
If it is controlled by the UCCNC is what I can talk about is that if there is no M5 delay setup then there should be no more than a few tens of milliseconds delay.

If it's controlled by the Neuron then there may be a setting in the plugin which causing the delay, but please ask Andrew (Shad) about this.
cncdrive
Site Admin
 
Posts: 2121
Joined: Tue Aug 12, 2014 11:17 pm

Re: M5 delay UCCNC+NeuronLite

Postby shad » Wed Feb 07, 2018 5:50 pm

Hello tonisson!
Please tell me, what plasma cutter do you use?
-- Andrew
UC400ETH
UC300ETH-5LPT
NEURON Lite THC
http://neuroncnc.com/
shad
 
Posts: 268
Joined: Thu Sep 15, 2016 5:23 pm

Re: M5 delay UCCNC+NeuronLite

Postby tõnisson » Wed Feb 07, 2018 9:32 pm

Powermax 85, but Olavi just said, that he sent email directly to you with the problem.



Kristian.
tõnisson
 
Posts: 2
Joined: Thu Feb 23, 2017 8:19 am

Re: M5 delay UCCNC+NeuronLite

Postby shad » Thu Feb 08, 2018 5:48 am

Yes Kristian, we try to check it today.
-- Andrew
UC400ETH
UC300ETH-5LPT
NEURON Lite THC
http://neuroncnc.com/
shad
 
Posts: 268
Joined: Thu Sep 15, 2016 5:23 pm


Return to CNC Plasma

Who is online

Users browsing this forum: No registered users and 1 guest