Re: MODBUSEZ Plugin
Posted: Sun Dec 16, 2018 9:21 amit is version 49...
forum.cncdrive.com
UCCNC machine control software support forum
http://forum.cncdrive.com/
MODBUSEZ Plugin
Page 16 of 21
Posted: Sun Dec 16, 2018 9:21 amRe: MODBUSEZ Plugin
Posted: Sun Dec 16, 2018 9:28 amThe modbusez was old though upgrading it now
Re: MODBUSEZ Plugin
Posted: Sun Dec 16, 2018 9:39 amIm running 49 version now with modbusez version 16. It is not saving my config, its reset every time I start UCCNC.
Re: MODBUSEZ Plugin
Posted: Sun Dec 16, 2018 10:02 amchanged min RPM to like 6000 and it worked (my spindle is 200 - 6000 though).
But the same thing occurs, spindle starts, stops in the middle of loading and then starts spinning again. No commands works.
Maybe it uses other registers ?
But the same thing occurs, spindle starts, stops in the middle of loading and then starts spinning again. No commands works.
Maybe it uses other registers ?
Re: MODBUSEZ Plugin
Posted: Sun Dec 16, 2018 10:16 amspindle cw seems to be 0001
spindle ccw seems to be 0002
spindle off 0006
frequence is unknown
spindle ccw seems to be 0002
spindle off 0006
frequence is unknown
Re: MODBUSEZ Plugin
Posted: Sun Dec 16, 2018 12:17 pmmrping does this use a Modbus protocol for serial communication??? If not ModbusEZ isn't going to work out of the box. The manual gives no info.
Dan
Dan
Re: MODBUSEZ Plugin
Posted: Sun Dec 16, 2018 1:08 pmYes and CW, CCW, stop works with modbusez plugin.
its only the rpm left.
Can i read it out someway ?
its only the rpm left.
Can i read it out someway ?
Re: MODBUSEZ Plugin
Posted: Sun Dec 16, 2018 1:10 pmSee pic
Re: MODBUSEZ Plugin
Posted: Sun Dec 16, 2018 2:09 pm.
Re: MODBUSEZ Plugin
Posted: Sun Dec 16, 2018 8:31 pmYes with a Serial Monitor, you can try the free trial 1 here.>>> https://www.eltima.com/products/serial-port-monitor/
ModbusEZ divides you Max HZ with your max RPM and sends results in a high low byte in hex to register you input in settings.
For example with your settings, you set your RPM to 3000 it's going to send 25HZ (hex 00FA) or (09c4) depending on frequency resolution setting. Don't have time today but will take a better look at your manual tomorrow and see if I can help.
Dan
ModbusEZ divides you Max HZ with your max RPM and sends results in a high low byte in hex to register you input in settings.
For example with your settings, you set your RPM to 3000 it's going to send 25HZ (hex 00FA) or (09c4) depending on frequency resolution setting. Don't have time today but will take a better look at your manual tomorrow and see if I can help.
Dan