Re: MODBUSEZ Plugin
Posted: Tue Mar 13, 2018 7:32 pm
hi Alex, hi dan,
what i tried now.
i connected 2 pc's together. each one with usb-rs485 converter.
then i ran a terminalprogram on each pc
from the pc with uccnc i sent a command and received it on the other pc.
closed terminalprogramm on uccnc pc
configured modbusez plugin
restarted uccnc
pressed reset
startet spindle (cw and after that i tried ccw)
but i didn't get a Signal on the other pc (terminalprogram) -- it seems that uccnc did not send any char to the rs485 port.
as i mentioned i am a totaly Newcomer and not firm with hard and software
so, is there anything else to configure in uccnc?
MODBUSEZ: 1.5.4
UCCNC: 1.2047
DEVICE: UC400ETH
FIRMW.: 1.1350
API: 2.1320
thx in advance
udo
what i tried now.
i connected 2 pc's together. each one with usb-rs485 converter.
then i ran a terminalprogram on each pc
from the pc with uccnc i sent a command and received it on the other pc.
closed terminalprogramm on uccnc pc
configured modbusez plugin
restarted uccnc
pressed reset
startet spindle (cw and after that i tried ccw)
but i didn't get a Signal on the other pc (terminalprogram) -- it seems that uccnc did not send any char to the rs485 port.
as i mentioned i am a totaly Newcomer and not firm with hard and software
so, is there anything else to configure in uccnc?
MODBUSEZ: 1.5.4
UCCNC: 1.2047
DEVICE: UC400ETH
FIRMW.: 1.1350
API: 2.1320
thx in advance
udo