forum.cncdrive.com

Hi,

AutoLevelerCA v1.0045 is out. There are some invisible improvements and support for G81 has been added.
also no more problems with PhCNC...

Have A Nice Day...

Cahit

Thought I would have a look at this but despite trying several times to download, it is corrupted.

Greolt wrote:Thought I would have a look at this but despite trying several times to download, it is corrupted.

What exactly is corrupted? I was able to download, unpack the archive and run UCCNC with this new plugin DLL. Haven't tested the plugin itself yet though.

Works ok for me

Cheers

Andrew

Its because its a *.rar file (not a *.zip file).

Use 7-zip, it will open a lot of file types.

Supported formats:
Packing / unpacking: 7z, XZ, BZIP2, GZIP, TAR, ZIP and WIM
Unpacking only: AR, ARJ, CAB, CHM, CPIO, CramFS, DMG, EXT, FAT, GPT, HFS, IHEX, ISO, LZH, LZMA, MBR, MSI, NSIS, NTFS, QCOW2, RAR, RPM, SquashFS, UDF, UEFI, VDI, VHD, VMDK, WIM, XAR and Z.
For ZIP and GZIP formats, 7-Zip provides a compression ratio that is 2-10 % better than the ratio provided by PKZip and WinZip

http://www.7-zip.org/

Opens fine for me

Used 7-Zip for years. Lol.

Downloaded it twice more with two different browsers. No good

Even tried two different online rar extractors. They all say it's no good.

repackaged as a zip (worked fine for me as a RAR with 7-zip), I dont open them directly from the browser anyway but open the file once virus scanned.

It fails when I try to open it directly (as a rar) from the brower as rar is no a registered filetype (well registered to a programme that is if it makes sense).

Still have two copies of the RAR, on my desktop that I downloaded last night. Always download first. Both no good. 7-Zip just says it cannot open them.

Dowloaded again just now. still the same. No idea why I am getting bad downloads.

Anyway your ZIP opened just fine. Thanks for that Rob.

And thanks too Cahit. I will have a look at your plugin.

The Rar downloads and extracts OK at me using Winrar 5.40.

hi,

while working with PhCNC, I have found the following error:
G1 X0.00002 was noted as G1 X-4E-05 in autoleveler, this gives an unknown gcode in UCCNC.

Have this fixed.

good day...