Rotary axis feedrate compensation based on radius?

[ger21]

Are there any current plans for implementing this?

[cncdrive]

Yes, it's panned for a relatively long time now, but currently I only know about a few functions which will be sure added in the next release,
because we did not workout the next development cycle's todo list yet, it will be done in the next few weeks.
We always reconstruct the list at the beginning of each cycle from the most uptodate informations we gathered from customers and the same time we also discuss and rethink the direction of the development.
So, at the moment I can't tell you where this function is on the list, will know more in about 2 weeks or so.