LED Z+ or Z- motion active

Here is where you can request new features or special features.

LED Z+ or Z- motion active

Postby Robertspark » Fri Jun 23, 2017 8:16 pm

Additional LED please, indicating Z+ and Z- motion (would be easier than the alternative which would be to monitor the defined STEP & DIR pins for the Z-Axis and then convert this into a psedo Z+ / Z- signal, allowing for some software debounce given the step signal could be Low / High at any time the plugin loop detects Z STEP pin status).

It does not need to be accurate just indicative of Z+ and Z- motion please / representative that Z+ or Z- is active (~250msec accuracy, maybe a little higher).

Thanks either way,
Robertspark
 
Posts: 1892
Joined: Sat Sep 03, 2016 4:27 pm

Return to Feature Request

Who is online

Users browsing this forum: No registered users and 7 guests