Bit difficult to explain......
Generic settings profile export for later import when installing a newer version of UCCNC.
the recommendation is to install a new profile with major upgrade.... it would be nice however to be able to export the generic settings (ports, pins, vel, acc etc) to later import if a new profile will have new items within it at present we can set up a profile with a mach3 xml import but it may be useful to provide similar functionality via generic profile export & backup too for when you over-write you're profile and then have to trace out your ports and pins (as you failed to write them down / have lost the scrap of paper) following the mach3 xml import for your axis vel and accel settings.
Thanks as always
Rob