generic settings profile export for later backup import...

Here is where you can request new features or special features.

generic settings profile export for later backup import...

Postby Robertspark » Thu Sep 15, 2016 9:17 pm

Bit difficult to explain......
:roll: :roll:
Generic settings profile export for later import when installing a newer version of UCCNC.

the recommendation is to install a new profile with major upgrade.... it would be nice however to be able to export the generic settings (ports, pins, vel, acc etc) to later import if a new profile will have new items within it at present we can set up a profile with a mach3 xml import but it may be useful to provide similar functionality via generic profile export & backup too for when you over-write you're profile :oops: and then have to trace out your ports and pins (as you failed to write them down / have lost the scrap of paper) following the mach3 xml import for your axis vel and accel settings.

Thanks as always

Rob
Robertspark
 
Posts: 1892
Joined: Sat Sep 03, 2016 4:27 pm

Re: generic settings profile export for later backup import.

Postby Robertspark » Thu Sep 15, 2016 10:23 pm

Thanks TP,

I did think about that (after the event...or overwriting it)

I then wondered about the recordation to use a new profile with a major upgrade and wondered if there was some way to port across the more generic settings to a new one
Robertspark
 
Posts: 1892
Joined: Sat Sep 03, 2016 4:27 pm


Return to Feature Request

Who is online

Users browsing this forum: No registered users and 1 guest