forum.cncdrive.com • View topic - is there a RTCP function in the plans?

Page 1 of 1

is there a RTCP function in the plans?

Posted: Fri Nov 26, 2021 9:56 pm

by Polyura

Tool tip position control... are you planning to add these great features?

Re: is there a RTCP function in the plans?

Posted: Fri Nov 26, 2021 10:12 pm

by cncdrive

I don't even know what that is?

Re: is there a RTCP function in the plans?

Posted: Sun Nov 28, 2021 12:02 pm

by Polyura

https://infosys.beckhoff.com/english.ph ... cp.htm&id=

Re: is there a RTCP function in the plans?

Posted: Sun Nov 28, 2021 2:52 pm

by cncdrive

Hmm, no we did not plan implementing this, but looks like a good idea though. Will think about it, but I can't promise anything now.

Re: is there a RTCP function in the plans?

Posted: Mon Jul 18, 2022 9:10 pm

by BKG

Any progress here ?

Re: is there a RTCP function in the plans?

Posted: Tue Jul 19, 2022 12:38 pm

by cncdrive

No, we did not make any progress on this yet sorry.