Feeds and speeds calculation tab

[Robertspark]

I know TP has one... but I was wondering about a simple feeds and speeds calculation via a tab..... maybe a wizards tab... and then we can add sub tabs under that?

Is there a way that the screenset could maybe call in another screenset tab....that way simple wizards could be written and simply linked to from the main screenset


Also looking for a bit of guidance of feeds and speeds for drills.... anyone got a link or any guidance?

[Robertspark]

Thanks TP.

I'm a fan of cobalt drills, always served me well, the hss ones in this part of the world can be mostly Chinese (keep in a cool place) unless specifically dorma...

Use to sharpen them on a bench grinder... saw the light, and bought a drill doctor 750x... no thought required.. set angle, set depth, sharpen... split point if desired, perfect every time, not a blunt drill in sight (very satisfying sharpening drills one after another... like pencils in a good school classroom helix type pencil sharpener ... stress relief )

Would be nice to maybe get user tabs back if not too much to ask cncdrive?