forum.cncdrive.com

Hello everyone,
I recently purchased a tool probe similar to Renishaw's TS27R probes for much less on ​AE https://urls.fr/8UmxJI.
Do you think it's possible to modify the M6 ​​macro so that it triggers the spindle in CCW with a small rpm and an offset from the axis of half the diameter in order to have accurate probing regardless of the cutter size?
You might be able to understand better with a video https://urls.fr/g-WpVS

Thx

Hi,
I tried to modify the macro myself, but I couldn't do it. I still lack the knowledge and practice for this.
I asked "Deep Seek" and he gave me the lines to add to the macro. It's between "exec.Callbutton(848); " and "exec.Miston();".
I haven't been able to try it yet, please let me know if you think it makes sense.

Well, I think I got a bit carried away, I got an error message, I'm going to take the macro again and go step by step, I'll post the progress.