Page 1 of 1

Setting up macros

PostPosted: Sun Nov 26, 2023 5:26 pm
by AXBB
Hi

I am looking for probing and ATC macros of an AXBB controller with UCCNC.

Linear magazine. Tool holders pick up from above.

Re: Setting up macros

PostPosted: Sun Nov 26, 2023 7:51 pm
by dezsoe
You can find a linear magazine ATC sample macro (M6) in the macro folder, it just needs customization for your machine.

Also, you can find a whole probe screen in UCCNC. If you don't want to use the probe screen then check the M31 macro in the same macro folder.