Here is where you can request new features or special features.
-
- Jog Safe Probe Button
by ger21 » Mon Nov 28, 2016 1:21 am
- 3 Replies
- 10002 Views
- Last post by ger21
Sat Dec 17, 2016 5:31 pm
-
- Start a macroloop via a button press.
by beefy » Fri Dec 09, 2016 5:50 am
- 0 Replies
- 4618 Views
- Last post by beefy
Fri Dec 09, 2016 5:50 am
-
- Flashing LEDs
by beefy » Fri Dec 09, 2016 5:44 am
- 0 Replies
- 4625 Views
- Last post by beefy
Fri Dec 09, 2016 5:44 am
-
- Radius compensation?
by A_Camera » Wed Dec 07, 2016 2:09 pm
- 13 Replies
- 34594 Views
- Last post by ger21
Thu Dec 08, 2016 3:32 pm
-
- Is there any way to speed up macro execution?
by ger21 » Thu Nov 24, 2016 1:01 pm
- 22 Replies
- 61743 Views
- Last post by cncdrive
Tue Dec 06, 2016 11:58 pm
-
- Axis Homing Slow Down Zone
by CT63 » Wed Nov 30, 2016 2:31 am
- 2 Replies
- 8822 Views
- Last post by CT63
Wed Nov 30, 2016 3:37 am
-
- G18/G19
by alex_s » Tue Nov 29, 2016 3:36 pm
- 2 Replies
- 8658 Views
- Last post by alex_s
Tue Nov 29, 2016 4:15 pm
-
- Run macros from button with g-code loaded
by ger21 » Mon Nov 28, 2016 3:40 am
- 1 Replies
- 6214 Views
- Last post by cncdrive
Mon Nov 28, 2016 11:55 am
-
- Save User Checkbox State to Profile.
by ger21 » Sat Nov 19, 2016 12:30 am
- 5 Replies
- 14448 Views
- Last post by ger21
Sat Nov 19, 2016 5:18 pm
-
- Has G85 been implemented?
by Derek » Tue Nov 01, 2016 10:44 am
- 5 Replies
- 18653 Views
- Last post by cncdrive
Thu Nov 03, 2016 10:39 pm
Return to Board index
Who is online
Users browsing this forum: No registered users and 5 guests
Forum permissions
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum